My Moment In Time

Saturday, September 5, 2009

Item used for Baby Girl Card:

Cuttlebug Embossing Folder: Spots & Dots, Joann's or http://www.ohmycrafts.com/

Paper - Nana's Nursery - Joann's

I did case this card but have forgotten where I found it.

No comments:

Post a Comment

10 DAY TRIAL OR BUY YOUR SURE CUTS A LOT (SCAL) HERE!

The trial version will cut a horizontal lines through your design as a DEMO watermark. You have 10 days to try out the software. After 10 days, if you wish to continue to use the software, you must purchase a license. Click PURCHASE below to purchase to start your free 10 day trial.

Enjoy creating with this awesome Sure Cuts A Lot (SCAL2)program from Craft Edge.
PURCHASE

INDEX

PRODUCTS
If you don't want to buy more cartridges for your Cricut Machines (Cricut, Expression and Create ) and if you want to cut using all your TTF, dingbat files and many, many shape files, this is the program for you.

This program is easy to install and use. All you have to do to get started is use the link I have provided below and within a few minutes you are ready to go.

HOW TO UPDATE YOUR FIRMWARE

Cricut Firmware To be able to use "Sure Cuts A Lot" with your Cricut Machine, your Cricut machine must have the following firmware version: • Cricut Personal - v1.1 or 1.3 • Cricut Expression - v2.1 or 2.3 • Cricut Create - v1.51 WHEN I UPDATED MINE, I got 1.52 and it works just fine!!! • To find the firmware version currently on your Cricut Machine, turn your Cricut machine on and it should immediately indicate in the display on your Cricut machine, which version you currently have. If you do not have the required firmware version, you will need to update the firmware on your Cricut Machine. Currently the only way to do this is through ProvoCraft's Cricut Design Studio software. There is a Trial version available for Windows (XP SP2/Vista ) (If you have a Macintosh and need to update your firmware, you must do it from a Windows machine), which you can install for free and update the firmware on your Cricut machine. The following are steps to update your firmware using the Cricut Design Studio software: 1. Connect your Cricut machine to your computer. Make sure it is connected directly and not through a USB hub. 2. Start the Cricut Design Studio software 3. Make sure your Cricut machine is turned OFF. 4. Put your Cricut machine into Firmware update mode, by press and hold down the Stop button, and then press the Power button. You must keep the Stop button pressed down until the Cricut machine beeps at you (usualy in about 5 seconds). At this point, your Cricut machine is now ready to receive the update. 5. Choose "Update Firmware". The update can take anywhere from 5 to 10 minutes. If the process finished significantly faster than 5 minutes, the update most likely failed, and you will need to start the process again from the beginning.